1.Insert the TF card (4G, 8G or 16G) in the Card Reader. 2.Format the TF card in the following way,…
1.Open SuvCE 2.Choose Equip ->Set Rover 3.The manufacture choose: NMEA GPS Receiver , and model choose: Generic As the figure…
Qmini M3 BaudRate Setting Try to set the BaudRate to 19200 with the help of Hi - Q~~Tools~~Com Tool ,…
1.Run Hi-Net Server Software,to Tools Update with post diff result. 2.Mark on use log file, then click on change to…
1.Tool->Data Import. 2.Click Add->change (define the saving path)->Next. 3.Choose coordinate system. Add Predefined means you can use the one that…
1.Run Hi-Net Server Software, Go to: Tools> Update with post diff result. 2.Mark on “use log file”, then click on…
1.Open "SSCOM" software,choose right com port and Open port. 2.Choose right parameter,baudrate 19200 etc. 3.Click EXT. 4.Click one by one…
1.Prepare a *.txt file that contain the points details in a correct format. 2.Click "Survey"and chose the point library you…
1.Switch on Receiver, set as UHF mode. 2.Run “GM-xxPx management software” program, choose your COM Port and baud rate “19200”…
1.Open Hi-RTK software, connect the GPS of V30. 2.After connecting GPS successfully, click Information->iRTK Setting->Set Irtk. 3.Choose the language as…
1.Open the Hi-RTK software. 2.Click"Survey"to go to the interface. 3.Click the "DXF" at the bottom of interface. 4.Then click "Load"…
Use Hyper Terminal for update firmware. 1.As for total station,go to fileman,then download. 2.Input the pin code 82543,total station will…
you must use Hyper Terminal to update firmware. 1.As for total station,go to fileman,then download. 2.Input the pin code 82543,total…
There are manual about the software to transfer the data.
1.Install driver of data transmission. 2.Transmit data through RS232C communication line. 3.Transmit data through the SD card. 4.Transfer data through…
1.Level total station, put a reflector 30m forward. 2.Switch on the instrument,turn on the laser. 3.Aim at the center of…
1.Set paramaters with total station. 2.Device connect with total station. 3.Do survey work and collect the point on the device.…
1.Click the"Start"and then click"Setting"icon. 2.Click"System"icon. 3.Click"Remove Programs"icon. 4.Highlight the software and click"Remove"button. 5.Click"Yes"to confirm. Then the un-installation begin.
1.Install Hi-Target Geomatics Office(HGO) software on your PC. 2.Download the data from Hi-Target GNSS receiver to PC. 3.Run HGO software,…
This website uses cookies.